Circulation pump adjustment

Circulation pump adjustment

It is enough to follow a few steps for the circulation pump assembly. If the installation where you will install your pump is new, it is strongly recommended that you do an internal cleaning first. Take care to use heat resistant gaskets during assembly. Ensure that the arrow direction of the pump points towards the boiler and also secure the electrical components of the pump with an electrical panel suitable for the highest current specified on the pump. Set the stage where you will use the pump. Grounding in the electrical installation is an important detail. If the pump is to be used in cooling installations, take precautions against freezing and pay attention to the isolation of the system. If the pump will be at lower levels, such as in the basement, then it would be beneficial to make a drainage pit to prevent flooding. A drainage pump can also be used if needed.

How to choose a circulation pump?

There may be different fluids such as boiling water, hot oil, steam, and these fluids may be performing the heat transfer in the system. The main thing to consider in the selection of the circulation pump is the purpose of use and the fluid. After determining for what purpose and where the circulation pump will be used, which fluid will be used is one of the factors affecting the selection. One of the things to consider when choosing a circulation pump is flow rate and head. Flow rate is the scale that determines the amount of water that must circulate in the installation in order to heat the building. It must comply with the relevant standards.